GW Instek GPP-3060 - Set Group Parameter

BASIC OPERATION
69
perform the function of closing
Delay .
In Delay ON, the F1 (Restart) button
appears, it means that start from the
first; in CH1/CH2 running delay,
the F2 (Sync) button appears, it
means that two channels start from
the first at the same time.
Warning
If the channel has been in Output
ON before Delay function, the status
remains unchanged until Delay.On
so that the corresponding waveform
starts to output.
Set Group Parameter
Description
Each Group consists of Vltage, Current and Time.
Therefore, properly confirm parameter of each group is
correct before setting Delay output.
Parameter
Descriptiom
No.
Group number. Maximum 2047
State
Output status of each group: On,
Off
Time
Execution duration of each group.
Range: 1s – 300s
Patterm
Set the initial status of initial group.
01 Patt: start from Off; 10Patt: start
from On
Time set
It is used to generally set the pattern
of time change. Model is for the
changes covering fix (FixTime),
increase (Increase) and decline