GW Instek GPP-3060 - Page 53

BASIC OPERATION
53
(b) Step input: Press
the left or right arrow
buttons to select high
and low level that
require fine tune
(underline below the
corresponding
number value), and
scroll the scroll wheel
to increase or
decrease setting
value.
OVP
OCP
The setting method is identical to
Source.
Operation
ON/OFF
The button ON/OFF of CH1/CH2 is
individually available, while All
ON/OFF button is available for all
channels.
Mode
CV CC
CR
Font color appears
in orange under
Load mode.
Note
In CR mode, the external power supply must provide the
current required for I = V / R, otherwise the output ports
V and I will fluctuate.