H3C S5130S-EI series Hardware Information

4-59
Table4-11 SFP+ copper cables available for the SFP+ ports
SFP+ copper cable Max transmission distance
LSWM1STK 0.65 m (2.13 ft)
LSWM2STK 1.2 m (3.94 ft)
LSWM3STK 3 m (9.84 ft)
LSTM1STK 5 m (16.40 ft)
Table4-12 SFP+ fiber cables available for the SFP+ ports
SFP+ fiber cable Max transmission distance
SFP-XG-D-AOC-7M 7 m (22.97 ft)
SFP-XG-D-AOC-10M 10 m (32.81 ft)
SFP-XG-D-AOC-20M 20 m (65.62 ft)
Figure4-1 10-GE SFP+ cable
(1) Connector
(2) Pull latch
NOTE:
•
As a best practice, use H3C SFP/SFP+ transceiver modules or SFP+ cables for the SFP+ ports
.
•
The H3C SFP/SFP+ transceiver modules and SFP+ cables available for the SFP+ ports are
subject to change over time. For the most up-to-date list of H3C SFP/SFP+ transceiver modules
and SFP+ cables available for the SFP+ ports, contact your H3C sales representative or
technical support engineer.
•
For the specifications for the H3C SFP/SFP+ transceiver modules and SFP+ cables, see H3C
Transceiver Modules User Guide.
Combo interface
The S5130S-28P-HPWR-EI, S5130S-28S-HPWR-EI, S5130S-28P-HPWR-EI-AC, and
S5130S-28S-HPWR-EI-AC switches each provide four combo interfaces. The S5130S-12TP-EI,
S5130S-28TP-EI, S5130S-52TP-EI, S5130S-12TP-HPWR-EI, and S5130S-52F-EI switches each
provide two combo interfaces. The S5130S-28F-EI and S5130S-28PS-EI switches provide eight
1
2

H3C S5130S-EI series Specifications

General

Series	S5130S-EI
Category	Switch
MAC Address Table Size	16K
VLAN	4K VLANs
Management	Web, CLI, SNMP
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Operating Humidity	5% to 95% (non-condensing)
Ports	10/100/1000BASE-T ports
Layer Support	Layer 3
Stacking	Supported
Power Supply	AC/DC
PoE	Supported on some models
Dimensions (W x D x H)	440 x 43.6 mm