126
Using 95 mm seal driver, press endcap into gearbox until flush. 3.
F. Install new input shaft oil seal.
Turn gearbox over. 1.
Coat outer surface (mates with gearbox) of input shaft oil seal with Loc-2.
tite 680™ (or equivalent).
Place input shaft oil seal onto input shaft with smooth part of seal body 3.
facing end of shaft (outward).
Push input shaft oil seal down input shaft until seal mates with gearbox. 4.
Using seal driver, drive input shaft oil seal into gearbox until flush. 5.
Return to the calling bench procedure or paragraph 5.9.2, Gearbox Bench Procedures (on
page 120), for gearbox to pump (unit) assembly and unit installation in apparatus instructions
references.
5.9.2.1.1 Input Shaft Oil Seal (ONLY)
If the oil seal is the ONLY input shaft component requiring replacement perform this procedure to
replace ONLY the input shaft oil seal.
The oil seal for the input shaft is located on the drive side of the gearbox. The oil seal utilizes a
metal body that surrounds the seal. The oil seal must be replaced whenever the input shaft is
removed since the oil seal is Loctited in place (this prevents seal movement which would cause
an oil leak) and there is no way to remove the oil seal without damaging it. Therefore, the oil seal
is typically replaced as part of any input shaft or drive gear R&R procedure.
Replacing the input shaft oil seal without the removing the pump and gearbox is the preferred
method for this procedure however, this procedure typically requires gearbox removal prior to
performance due to limited access. If the pump and gearbox must be removed for access pur-
poses, see paragraph 5.8.2.1 for reference to the required Removal From The Apparatus proce-
dure. Refer to Table 42 for a list of tools and/or consumables required for this procedure.
Table 42. Input Shaft Oil Seal Bench Procedure Tools And Consumables List
PPE (Eye and Hand Protection) None Shop Rag(s) (As Required)
PPE (for Handling Oil) Loctite 680
Oil Safe Catch Container
(1.5 L or larger)
Oil Seal (Input Shaft, Drive Side Of Gearbox)
<See FSG–PL–01481, Sheet 2, Item 2>
9/16-in Wrench
(or 8 pt. socket)
3-in PVC Pipe (Schedule 40 ONLY) 3 Inches Long
(Pusher Tube)
Seal Removal Tool
Seal Driver Kit
Ratchet
Non-marring Hammer
10 mm Hex Socket
* Optional.
Perform the following to remove and replace ONLY the input shaft oil seal.
To Next Page
Loading...