78
Refer to Table 29 for a list of tools and/or consumables required for this procedure.
Table 29. MBP/RSD Inducer R&R Tools And Consumables List
PPE
(Eye and Hand Protection)
Torque Limiting Exten-
sion 210 ft-lb (285 Nm)
Shop Rag(s) (As Required)
2-1/2-in Socket and
Ratchet (RSD)
Torque Limiting Exten-
sion (110 ft-lb [149 Nm])
Grease (See paragraph 5.7.2 on page 49.)
1 3/4-in Socket and
Ratchet (MBP)
Puller Set
(See APPENDIX B)
O-ring Lubricant (See Table 20, page 49.)
Torque Wrench (MBP)
110 ft-lb (149 Nm)
Key (Inducer To Pump Shaft)
<See FSG–PL-01486 or –01487 Sheet 5 Item 2>
Torque Wrench (RSD)
210 ft-lb (285 Nm)
Inducer
<See FSG–PL-01486, Sheet 4, Item 6> (MBP)
<See FSG–PL-01487, Sheet 4, Item 22>(RSD)
Cold Cut Chisel Cotter pin (Inducer Nut To Pump Shaft)
<See FSG–PL-01486, Sheet 4, Item 5> (MBP)
<See FSG–PL-01487, Sheet 4, Item 9> (RSD)
Flat Blade Screwdriver Gasket
MBP (Volute to Pump Head)
<See FSG–PL-01486, Sheet 4, Item 9>
RSD (Suction Head To Volute)
<See FSG–PL-01487, Sheet 4, Item 3>
Hammer O-RING
MBP (Volute to Pump Head)
<See FSG–PL-01486 Sheet 4 Item 10>
RSD (Suction Head To Volute)
<See FSG–PL-01487, Sheet 4, Item 30>
Heavy Wire Cutters
Impact Driver
Pin (or Drift) Punch
Plyers
Perform the following to remove and replace the inducer.
USE PPE TO PROTECT HANDS AND FINGERS FROM SHARP EDGES. THE EDGES OF
THE BLADES ON THE INDUCER MAY BE SHARP.
Inducer Removal
A. Remove cotter pin that secures inducer nut.
Using flat blade screwdriver, pry bent portion of cotter pin so bend can be 1.
cut off or driven out of pump shaft.
Using heavy wire cutters, cut off bent portion of cotter pin. (Or using ply-2.
ers, bend cotter pin straight.)
To Next Page
Loading...
