34
!
Edge sanders
HS 950
Only use appropriate sanding belts:
14.2.0835
5 x Sanding belts 2515 x 150 mm K80
14.2.0845
5 x Sanding belts 2515 x 150 mm K100
14.2.0855
5 x Sanding belts 2515 x 150 mm K120
14.2.0865
5 x Sanding belts 2515 x 150 mm K150
8.2.2 Storing the sanding belts
8 Making adjustments and preparations
8.1 Safety instructions
Warning! Danger! Electric current!: Work on electrical fittings may only be carried out by qualified personnel
and in strict observance of the safety instructions.
Warning! Risk of injury!: Improper adjustment and setup work can lead to serious physical injury or
material damage. For this reason, this work may only be carried out by authorised, trained personnel who
are familiar with how to operate the machine and in strict observance of all safety instructions.
• Before beginning any maintenance work on the
machine, switch it off and secure it against acciden-
tally being switched on again.
• Before commencing any work with the machine,
inspect it to ensure that it is complete and in
technically good condition.
• Ensure that there is sufficient space to work around
the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Install the safety equipment according to the
instructions and check that it functions properly.
Making adjustments and preparations
Warning!: Avoid all contact with rotating sanding belts! Never clean the sanding belts whilst they are still in the
machine! Remove them beforehand and clean them outside the machine!
Attention!: Always loosen the tension of the sanding belts when the machine is not in use!
8.2 Sanding belt
8.2.1 Sanding belts
• Never use a torn sanding belt.
• Only use appropriate sanding belts.
• Ensure that the surfaces of the rollers are clean and
free of dust before attaching a sanding belt.
Note:
Store the sanding belts carefully. Storage conditions with a temperature ranging between 16 and 25 degrees
Celsius (60 to 80 degrees Fahrenheit) and a relative
humidity of 40 % to 60 %.
To Next Page
Loading...