44
Edge sanders
HS 950
Interval: Component Task to accomplish
Daily
Machine Remove dust and shavings
Table surfaces Remove dust and shavings
Infeed fence Remove dust and shavings
Dust extractor Check for defects
Sanding belt Damage and function check; replace if
necessary
Drive wheels Remove dust and shavings from the
bearing tracks.
Every 40 operating hours, At
least once a month
Dust extractor Check efficiency
every 6 months
Height adjustment of the working table Control and lubrication (if required)
guiding shaft - side working table Control and lubrication (if required)
Tiltable table Control and lubrication (if required)
Service
10 Service
10.1 Safety instructions
Warning! Risk of injury!: Improper maintenance can cause serious injury or damage. For this reason, this
work may only be carried out by authorised, trained personnel who are familiar with how to operate the
machine and in strict observance of all safety instructions.
• Before beginning any maintenance work on the
machine, switch it off and secure it against accidentally
being switched on again.
• Ensure that there is sufficient space to work around
the machine.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Following the maintenance work, reinstall the guards
and check that they are functioning properly.
Warning! Danger! Electric current!: Work on electrical fittings may only be carried out by qualified personnel
and in strict observance of the safety instructions.
10.2 Maintenance schedule
Note: Cleaning and care products are available as accessories
(see: Tools and Accessories catalogue)
To Next Page
Loading...