Hammer HS 950 - Working Techniques Overview; Correct Working Position; Authorised Working Techniques; Prohibited Working Techniques

40
AP2
AP1
Edge sanders
HS 950
Take up the position as shown in the opposite picture
when working with the machine
AP1: Work area for grinding rectangular or square
workpieces
AP2: Working area for curved workpieces
9.4 Working techniques
Operation
9.4.1 Working position
9.4.2 Authorised working techniques
9.4.3 Prohibited working techniques
Prohibited working techniques are those which must
never be carried out on this machine!
• Grinding of metal parts e.g. planer knifes
• Removing a standard cover
All other working techniques that deviate from the fol-
lowing uses are improper on this machine and therefore
not permitted:
• Grinding of longitudinal sides on the longitudinal
grinding side of the machine
• Grinding of longitudinal sides on the longitudinal
grinding side of the machine with pivoted sanding
unitt
• Grinding of end faces by means of a swivelling
stop fixed to the work table with swivelled or non-
swivelled sanding unit
• Grinding on the roller
Fig. 9-3: Work place/work position