6 - Maintenance
106
50 Hours Service - Greasing the Pump
When operating the pump, it must be greased every 50 hours with 30
grams of grease into each lubrication point.
ATTENTION! In order to avoid excessive wear, it is important to
use a recommended lubricant (i.e. HARDI® part no. 28164600).
See “Recommended Lubricants” on page 95 for more
information.
ATTENTION! The pump MUST be stopped during greasing!
50 Hours Service - Wheel Nuts
Tighten wheel nuts as follows:
Mounting wheel hub to rim plate: Torque 360 Ft/lb (490 Nm).
Tightening sequence: See illustration and tighten in the order of
numbering.
50 Hours Service - Tire Pressure
Check the tire pressure according to the table in “Tire Pressure” on
page 149.
€
DANGER! Never inflate tires more than to the pressure specified
in the table. Over-inflated tires can explode and cause severe
injuries! See the section “Occasional Maintenance - Change of
Tires”.
±
WARNING! If renewing tires, always use tires with minimum load
index as specified.
To Next Page
Loading...
Need help?
General
