2 - General Safety Instructions
14
Representation of Safety Symbols
Explanation of Symbols
Safety symbols are used in the following chapters throughout this Instruction Book to designate where the reader needs to
pay extra attention.
The signal word (DANGER, WARNING, ATTENTION or NOTE) describes the severity of the risk.
The symbols have the following meaning:
€
This symbol means DANGER. Be very alert as your safety is involved! The DANGER symbol indicates a high risk for
immediate death or serious physical injury if the instruction is not followed.
±
This symbol means WARNING. Be alert as your safety can be involved! The WARNING symbol indicates a medium risk
for serious injury or death if the instruction is not followed.
This symbol means ATTENTION. This indicates important information required for proper sprayer handling. This
instruction will help you avoid problems with the sprayer or disturbance to the environment.
÷
This symbol means NOTE. This indicates handling tips and particularly useful information. This instruction will help
you to use all the functions of your sprayer in the best way possible for a better, easier and safer operation.
General Info
€
Note the following recommended precautions and safe operating practices before using the sprayer:
• Local law may demand that the operator is certified to use spray equipment. Adhere to the law.
• The driver's seat is the intended working place during operation.
• Wash and change clothes after spraying. Wash tools if they have become contaminated.
• Do not eat, drink or smoke while spraying or working with contaminated equipment. In case of poisoning,
immediately seek medical advice. Remember to identify chemicals used.
• No persons are allowed in the operation area of the sprayer. Be careful not to hit people or surroundings when
maneuvering the sprayer, especially while backing up.
• Slow down when driving in uneven terrain as the machine might be in risk of turning over.
• Keep children away from the equipment!
• Do not attempt to enter the tank.
• Do not go under any part of the sprayer unless it is secured. The boom is secure when placed in the transport brackets.
• Pressure test with clean water prior to filling with chemicals. Never disconnect the hoses if the machine is in operation.
• DANGER! Do not exceed the P.T.O. max. recommended rpm.
• Rinse and wash equipment after use and before servicing.
• Never service or repair the equipment while it is operating. Always replace all safety devices or shields immediately
after servicing.
• Disconnect electrical power before servicing and depressurize equipment after use and before servicing.
• If an arc welder is used on the equipment or anything connected to the equipment, disconnect power leads before
welding. Remove all inflammable or explosive material from the area.
• The External Cleaning Device should not be used if essential parts of the equipment have been damaged, including
safety devices, high pressure hoses, etc.
To Next Page
Loading...
Need help?
General
