2 - General Safety Instructions
17
Safety and Protection Equipment
Safety at Start up
Each time before the sprayer is started up, all the safety and protection equipment must be properly attached and fully
functional.
Check the sprayer at least once a day under normal operation for visible damage. Check the function of the safety and
protection equipment.
Repair or replace the equipment as needed.
Only operate the sprayer if all the safety and protection equipment is fully functional.
Faulty Safety Equipment
Faulty or disassembled safety and protection equipment can lead to dangerous situations.
Additional Safety Instructions
Together with the safety information in this Instruction Book, also comply with the general and local regulations related to:
• Accident prevention.
• Environmental protection.
• The applicable workplace safety.
Follow these regulations, especially when:
• Driving on public roads and routes. Comply with the appropriate statutory road traffic regulations. These vary from
state to state, and there may be local regulations which need to be followed.
• Local law demands that the operator is certified to use spray equipment.
• Using pesticides or liquid fertilizer. Make sure you understand the information from the supplier regarding their use.
€
Never service or repair the equipment while it is operating. Always replace all safety devices or shields immediately
after servicing.
€
Disconnect electrical power before servicing and depressurize equipment after use and before servicing.
€
If an arc welder is used on the equipment or anything connected to the equipment, disconnect power leads before
welding. Remove all inflammable or explosive material from the area.
€
The External Cleaning Device should not be used if essential parts of the equipment have been damaged, including
safety devices, high pressure hoses, etc.
To Next Page
Loading...
Need help?
General
