16
ASSEMBLY AND INSTALLATION
6
● Handle molded parts with care. Excessive weight or pressure may cause them
to break and the broken pieces may cause injury.
● To perform the operation safely and accurately you must use a safe, steady
footstool or stepladder. Working without this may lead to a fall and possible
injury.
● When connecting the connectors on the DVD wire, you must carefully check
the tags on the wire to nd the correct connector. Even when you have
the correct connector, you must pay careful attention to the direction and
angle of insertion. Attempting to forcefully connect the incorrect connector
or connecting a connector at the wrong angle or facing may damage the
connector and could lead to overheating and burn related injuries.
● When attaching or removing doors or lids, be careful that your hand or nger
does not get caught in anything.
● Be very careful when handling the LED display screen. The screen can be
damaged easily and cannot be repaired once damaged. Such damage can
only be repaired by completely replacing the screen.
● Be careful not to damage parts surfaces. In some cases, if such surfaces are
damaged, the part must be replaced; it cannot be reinforced or repaired.
To Next Page
Loading...
Need help?
General