50
PRECAUTIONS WHEN MOVING THE MACHINE
7
● Always disconnect the power cable before moving the product. If it is moved
with the power cable connected, the cable could be damaged, causing re or
electric shock.
● To move the unit over the oor, pull in the adjustors and have the casters
contact the oor. While moving the unit, be careful that the casters do not roll
over the power cord or the ground wire. If cord or wire is damaged, there could
be electrical shocks and/or short circuits.
● When crossing a sloped or stepped area, disconnect the Monitor Cabinet and
Rear Cabinet. If you tilt them while connected together, the connection points
may be damaged and personnel could be injured.
● When lifting the cabinet up steps, you must hold it by the designated handles
or by the bottom surface. Lifting it by any other area may lead to damage or
disguration to that part or surrounding parts due to the weight of the cabinet
and could also lead to injury of personnel.
● When tilting the cabinet to move it across a sloped or stepped area, always use
at least two people. Attempting such an operation alone can lead to accident
or injury.
● When moving the components separately, take care concerning the direction
you push the Monitor and Rear Cabinet in. These elements may fall over,
causing damage or an accident.
● When moving the components, do not push any of the plastic elements or
shaped parts and do not use them to pull the components along. This may
damage the parts or the surrounding parts and this could lead to accidents or
injury.
● After dividing the components to move them, do not use the Control Units in the
Monitor Cabinet to push or pull the cabinet. This may damage or disgure these
parts and lead to malfunctions or injury.
● When moving the separated components, be sure to push/pull each cabinet
lengthways. Trying to move the cabinet any other way may cause the cabinet
to topple over.
7-1 MOVING THE MACHINE
7
PRECAUTIONS WHEN MOVING
To Next Page
Loading...
Need help?
General