20
ASSEMBLY AND INSTALLATION
6
1
Carefully unpack the machine. Locate the parts
listed below and place to one side. Remove the
2 parts of the machine from the pallet (Monitor
cabinet and Rear cabinet) using suitable lifting
equipment.
In this product the cabinet that contains both the MONITOR cabinet and GUN cabinet and will be simply referred to
as the “MONITOR cabinet”
● Be very careful when removing the Monitor and Rear cabinets from the pallet.
Use only hydraulic lifting equipment such as a fork lift. DO NOT attempt to
remove the machine from the pallet by hand. Doing so may result in serious
personel injury and/or damage to the cabinet and its components.
● There are 4 “LIFTING POINTS” highlighted on the lower front and rear parts of the
machine by a symbol. Always use these points when lifting.
FIG. 6-1d
FIG. 6-1e
Floor Panel
Monitor Cabinet
Rear Cabinet
Please note:
During transit the roof for this machine is placed
inside the seating of the REAR CABINET with the
Billboard and Exhaust Pipes. Some components
and brackets are also contained within the Top Box
container.
Top Box Packaging
BILLBOARD
BRKT SHOULDER SUPPORT
POP PANEL
BRKT SHOULDER SUPPORT
EXHAUST PIPE
JOINT BRIDGE
POP PANEL SUPPORT BRKT
EXHAUST PIPE
To Next Page
Loading...
Need help?
General