56
PRECAUTIONS WHEN MOVING THE MACHINE
7
9
Disconnect the JOINT BRIDGE on both the left and right hand side from the REAR CABINET. Be sure
to disconnect the cabinet harnessing before
separating. Carefully prise the MONITOR
CABINET and REAR CABINET apart.
10
To reassemble, follow these steps in reverse order. Also refer to the Installation Guide within Section 6
of this manual. If the MONITOR CABINET is still too wide, remove the JOINT BRIDGE brackets and
compress the gun cabinet (see Section 6 for details on how to compress/extend the gun cabinet).
FIG. 7-2j
JOINT BRIDGE