Safety instructions
8 A0785-150 HBM: public T10FS
Cet appareil est conforme aux normes d'exemption de
licence RSS d'Industry Canada. Son fonctionnement est
soumis aux deux conditions suivantes : (1) cet appareil
ne doit pas causer d'interférence et (2) cet appareil doit
accepter toute interférence, notamment les interférences
qui peuvent affecter son fonctionnement.
Important
Usage/Installation in the USA and Canada requires an
EMI suppressor. Please refer to chapter 6.1.1, page 45.
Designated use
The T10FS torque flange is used exclusively for torque
and rotation speed measurement tasks, and directly
associated control and regulatory tasks. Use for any
additional purpose shall be deemed to be not as
intended.
In the interests of safety, the transducer should only be
operated as described in the Operating Manual. It is also
essential to comply with the legal and safety
requirements for the application concerned during use.
The same applies to the use of accessories.
The transducer is not a safety element within the
meaning of its designated use. Proper and safe operation
of this transducer requires proper transportation, correct
storage, assembly and mounting, and careful operation.
General dangers of failing to follow the safety
instructions
The transducer corresponds to the state of the art and is
failsafe. The transducer can give rise to remaining
dangers if it is inappropriately installed and operated by
untrained personnel.
To Next Page
Loading...
Need help?
General
