HEIDENHAIN MANUALPLUS 4110 - Creating the Matrix Cycle Program: Simulate Finishing; Running Graphic Simulation of Matrix Finishing Cycle

HEIDENHAIN MANUALplus 4110 Surface Machining Example 8.7
Create the “Matrix” cycle program
Run a graphic simulation of the cycle
The tool-path simulation accounts for the exact geometry of the tool tip. Therefore, this
simulation is recommended for the finishing process.
 Test the cycle:
Press the Graphics soft key
Switch from path display to display of
the cutter:
 Call the additional functions
of the simulation:
Press the Extra functions
soft key
 Press the Track soft key
 Press the Slide soft key
 Conclude setting of the
additional functions:
Press the Back soft key
 Repeat the simulation with
new settings:
Press the Graphics soft key