HEIDENHAIN MANUALPLUS 4110 - Creating the Matrix Cycle Program: Execute Finishing; Running the Matrix Finishing Cycle

HEIDENHAIN MANUALplus 4110 Surface Machining Example 8.8
Create the “Matrix” cycle program
Run the cycle:
Program the “Approach tool change position” cycle
 Set the feed rate override
feed rate override to 0%
 Activate Cycle Start
 Slowly increase the feed
rate override. The finishing
cycle is performed.
 Save the cycle:
Press the Save soft key
 Press the Add cycle soft
key
 Press the Single cuts menu
key
 Press the Rapid traverse
positioning menu key