HEIDENHAIN MANUALPLUS 4110 - Creating the Matrix ICP Contour: Element 5; Contour Element 5: Oblique Cut

HEIDENHAIN MANUALplus 4110 Surface Machining Example 8.15
Create the “Matrix” ICP contour
Contour element 5 (oblique cut)
 Switch to line entry:
Press the Line soft key
 Press the Line menu key
Describe the contour element:
 Target point X in X: 4mm
 Target point Z in Z: 0mm
 Angle A to Z axis: 5.5°
 Length of line L: No entry
 Special feed rate F: No entry
 Conclude entry:
Press the Save soft key
(There are two solutions.)
 Display next solution:
Press the Next solution
soft key
(desired solution)
 Press the Select solution
soft key