HEIDENHAIN MANUALPLUS 4110 - Creating the Matrix ICP Contour: Superimposing Roundings; Superimposing Rounding Element 1

HEIDENHAIN MANUALplus 4110 Surface Machining Example 8.16
Create the “Matrix” ICP contour
Superimpose roundings
 Conclude the “rough
contour” input:
Press the Back soft key
 Press the Superimpose
form elements soft key
(Position for superimposing
is shown with a red square)
 Press the Rounding menu
key
Describe the superimposed element:
 Rounding radius B: 1 mm
 Special feed rate F: No entry
 Insert rounding:
Press the Save soft key
(Next position for
superimposing is shown)