HEIDENHAIN MANUALPLUS 4110 - Creating the Matrix ICP Contour: More Roundings; Superimposing Rounding Element 2

HEIDENHAIN MANUALplus 4110 Surface Machining Example 8.17
Create the “Matrix” ICP contour
 Press the Rounding menu
key
Describe the superimposed element:
 Rounding radius B: 2.5 mm
 Special feed rate F: No entry
 Insert rounding:
Press the Save soft key
(Next position for
superimposing is shown)
 Press the Rounding menu
key
Describe the superimposed element:
 Rounding radius B: 3.5 mm
 Special feed rate F: No entry
 Insert rounding:
Press the Save soft key
(Next position for
superimposing is shown)