HEIDENHAIN MANUALPLUS 4110 - Creating Tool T8: Threading Tool; Specifying Position for Threading Tool (T8); Entering Initial Data for T8

HEIDENHAIN MANUALplus 4110 Tool Management 4.10
Creating tool T8
Specify the position in the tool manager
Enter the tool data (part 1)
Threading tool T8 The setting dimensions are preliminarily entered
as 0.
 Place the cursor on position
T8: Press the arrow key
repeatedly
 Add a new tool:
Press the Add soft key
 Select the tool type:
Press the Threading tool
menu key
 Setup dimension X in X: 0 mm
 Setup dimension Z in Z: 0 mm
 Tool orientation WO: 1
(outside tool, machining direction
toward the chuck)
 Wear compensation DX in X: 0 mm
 Wear compensation DZ in Z: 0 mm