HEIDENHAIN MANUALPLUS 4110 - Creating Tool T8: Data Entry; Entering Tool Description for T8; Entering Part 2 of Tool Data (T8)

HEIDENHAIN MANUALplus 4110 Tool Management 4.11
Creating tool T8
Enter the tool description
Enter the tool data (part 2)
 Press the Tool text soft key.
 Place the cursor on position
Q3:
Press the arrow key
 Enter text:
Press the Change text soft
key
 Enter the text “Thread cut
tool Outside” with the on-
screen keyboard
 Press the Save soft key
 Save the text number to the
parameter Tool text Q:
Press the Take over text
no. soft key
 Press the Page forward key
 Machining direction MD M3=3, M4=4:3
(3=Machining direction to the right)
 Shaft speed TS: 600 rev/min