Fundamentals | Control model, software and features
20
HEIDENHAIN | TNC 320 | ISO Programming User's Manual | 10/2017
In the Test Run operating mode you can reset the tool paths
with the RESET TOOL PATHS soft key, see "3-D view in the Test
Run operating mode", page 590
In the Test Run operating mode the MEASURING soft key
displays the coordinates if you position the mouse on the
graphics, see "3-D view in the Test Run operating mode",
page 590
In the Test Run operating mode the STOP AT soft key simulates
up to a predefined block, see "Test Run up to a certain block ",
page 602
Active basic transformation is shown in the status display on the
POS tab, see "Positions and coordinates (POS tab)", page 88
The status display now also shows the path of the active main
program, see "Overview", page 86, see "General program
information (PGM tab)", page 87
In the status display the CYC tab now also shows T-Max and
TA-Max
Mid-program startup can now be continued, see "Entering the
program at any point: Mid-program startup", page 613
With functions NC/PLC Backup and NC/PLC Restore you can
save and restore single directories or the complete TNC drive,
see "Backup and restore", page 101
To Next Page
Loading...
