Hettich EBA 280 S - 11 Opening and Closing the Lid; Opening the Lid; Closing the Lid

EN
54/165
11 Opening and closing the lid
11.1 Opening the lid
The lid can only be opened if the centrifuge is switched on and the rotor is stationary.
If this shouldn't be possible, see the "Emergency unlock" chapter.
When the cycle counter is activated, after a centrifugation run, while opening the lid, the remaining number
of running cycles (centrifugation runs) is briefly displayed.
Example:
PROG t/min:sRPM
STOP
OPEN
 Press the key.
The lid is unlocked by the motor.
: Lid unlocked.
The left LED in the key will go out.
Example:
PROG t/min:sRPM
11.2 Closing the lid
Do not reach with your fingers between the lid and housing.
Do not slam the lid closed.
 Put the lid on and lightly press the front
edge of the lid down.
The lid is locked by the motor.
: Lid locked.
The left LED in the
STOP
OPEN
key is
illuminated.
Example:
PROG t/min:sRPM