Hettich EBA 280 S - Displayed Centrifugation Parameters after Switching on the Device

EN
73/165
20.6 Displayed centrifugation parameters after switching on the device
It can be set whether the centrifugation parameters of the last used program or of program 1 should be displayed
after switching on the device.
With the rotor at a standstill, this can be set as follows:
The procedure can be aborted at any time by pressing the
STOP
OPEN
key. In this case, the settings are not stored.
 Press and hold the button for eight
seconds.
PROG t/min:sRPM

 Press the key until the following is
displayed:
PROG t/min:sRPM

START
PULSE
 Press the key.
PROG t/min:sRPM PROG t/min:sRPM

 Press the key until one of the following is
displayed:
Start Pr : Displayed program after
switching on.
First : Program 1.
Last : Last used program.
PROG t/min:sRPM PROG t/min:sRPM

 Set First or Last with the keys.
PROG t/min:sRPM PROG t/min:sRPM

START
PULSE
 Press the key to save the setting.
PROG t/min:sRPM
PROG t/min:sRPM

STOP
OPEN
 Press the key once to exit the "
Settings"
menu or press twice to exit the "
MACHINE MENU
".
PROG t/min:sRPM
Example:
PROG t/min:sRPM