Hettich EBA 280 S - Backlighting of the Display

EN
72/165
20.5 Backlighting of the display
To save energy, it can be set that, after a centrifugation run, the backlighting of the display switches off after 2
minutes.
With the rotor at a standstill, this can be set as follows:
The procedure can be aborted at any time by pressing the
STOP
OPEN
key. In this case, the settings are not stored.
 Press and hold the button for eight
seconds.
PROG t/min:sRPM

 Press the key until the following is
displayed:
PROG t/min:sRPM

START
PULSE
 Press the key.
PROG t/min:sRPM PROG t/min:sRPM

 Press the key until one of the following is
displayed:
Power save : Automatic shutdown of the
backlighting.
off : Automatic shutdown deactivated.
on : Automatic shutdown activated.
PROG t/min:sRPM PROG t/min:sRPM

 With the keys, set off or on.
PROG t/min:sRPM PROG t/min:sRPM

START
PULSE
 Press the key to save the setting.
PROG t/min:sRPM
PROG t/min:sRPM

STOP
OPEN
 Press the key once to exit the "
Settings"
menu or press twice to exit the "
MACHINE MENU
".
PROG t/min:sRPM
Example:
PROG t/min:sRPM