Hettich EBA 280 S - Activating;Deactivating the Dual Time Function

EN
74/165
20.7 Activating/deactivating the "Dual time" function
In order to be able to set the runtime counter (parameter Begins at START and parameter Begins at SPEED), the
"Dual time" function must be activated. This function is activated ex works.
With the rotor at a standstill, this can be set as follows:
The procedure can be aborted at any time by pressing the
STOP
OPEN
key. In this case, the settings are not stored.
 Press and hold the button for eight
seconds.
PROG t/min:sRPM

 Press the key until the following is
displayed:
PROG t/min:sRPM

START
PULSE
 Press the key.
PROG t/min:sRPM PROG t/min:sRPM

 Press the key until one of the following is
displayed:
Dual time : Counting the runtime.
on : Function activated.
off : Function deactivated.
PROG t/min:sRPM PROG t/min:sRPM

 Set with the off or on keys.
PROG t/min:sRPM PROG t/min:sRPM

START
PULSE
 Press the key to save the setting.
PROG t/min:sRPM
PROG t/min:sRPM

STOP
OPEN
 Press the key once to exit the "
Settings"
menu or press twice to exit the "
MACHINE MENU
".
PROG t/min:sRPM
Example:
PROG t/min:sRPM