Connection
H00007091 - Absolute Arm User Manual │Version 5.2.0 (2019-03-07) │113
Software Installation:
1. Install Scanworks (type of device, select “ROMER NCA”).
2. Setup on-board Ethernet port as 192.168.19.1
Scanworks console automatically starts: the device is ready to use.
Scanner qualification
1. In Scanworks console, start Scanworks
2. Run the qualification window by Menu “Setup” > “Calibration”
3. Z-Scale verification: place the scanner above a plane surface, and do an Up-to-Down scan, including
all height range, then validate
To Next Page
Loading...
