Hexagon Absolute Arm RS5 - RS5 Scanner Safety Care

Appendix
H00007091 - Absolute Arm User Manual │Version 5.2.0 (2019-03-07) │221
RS5 Scanner safety care
Class 2M laser
The laser built into the product produces a visible red laser beam which emerges
from the bottom of the product.
Class 2 laser
The visual guide produces a visible red beam which emerges from the top of the
product.
Product in accordance with: IEC 60825-1: 2014, "Safety of Laser Products.
It complies with FDA performance standards for laser products except for
deviations pursuant to Laser Notice No. 50, Dated June 24, 2007.
Class 2 / 2M Laser
Products
These products are safe for momentary exposure but can be hazardous if you
deliberately stare into the beam.
Warning
From a safety perspective, class 2/2M laser products are not inherently safe for the
eyes.
Precautions
Avoid staring into the beam or pointing the beam at other people
Before all handling of RS5 Scanner for the assembly, disassembling, cleaning etc.,
check that the lasers are turn off.
Attention with use the RS5 Scanner sensor for the measurement of reflective
surface (specular), the use of a product to make surface matt is strongly
recommended.
Cleaning /
handling
Do not touch the optical window on the camera.
To clean the front glasses of the RS5 Scanner, use compressed air to remove loose
particles.
(If you use compressed air from a fingertip dispenser please be aware that in some
cases the spray could contain also parts of the propellant which causes pollutions).
For removing tough pollutions, use wadded-cotton tips. These tips should be used
in a careful way and only with very less pressure to avoid injuring the surface of the
glass.
Cleaning alcohol such as 3M
®
“Surface cleaner” can be used.
Do not use solvents.
The personnel user of the RS5 Scanner sensor must be sensitized with laser safety and must have taken
knowledge of this manual.