Measure with the arm
H00007091 - Absolute Arm User Manual │Version 5.2.0 (2019-03-07) │124
F.1.7 HOW TO USE THE ARM BUTTONS
Whatever the configuration is, the buttons present on the wrist have dedicated aims. The Trigger Button is
the “measurement” button, and the 3-State button, used for control.
Trigger Button (BT)
This main button is the one used to take points, start or stop scanning…
3-State Button (B3S)
This special button can be used for validating or cancelling (points, messages…) or for controlling the Quick
Access Menu.
Usually, the button is defined as the following:
Fig. 39 : 3-State button
However, depending on the software, the use of the buttons may be different. Please refer to the appendix
for specific application software setup.
To Next Page
Loading...
Need help?
General
