ID5000 Series Smart Code Reader User Manual
48
3. Select Counter 0 as Trigger Source.
4. Set Trigger Delay, Count Number, Count Source and Line Out Trigger In Polarity according to
actual demands.
Figure 8-26 Set and Execute Counter Trigger Mode
Set and Execute TCP Trigger Mode
TCP start specifies the TCP server as the source for the trigger signal. When the server receives the
specified string text, the trigger signal will be outputted.
Steps
1. Click I/O Control Settings → Input → Trigger Mode.
2. Select On as Trigger Mode.
3. Select TCP Start as Trigger Source.
4. Set Trigger Delay, TCP Trigger Port, and TCP Start Trigger Text according to actual demands.
Figure 8-27 Set and Execute TCP Trigger Mode
Set and Execute UDP Trigger Mode
UDP start specifies the UDP server as the source for the trigger signal. When the server receives
To Next Page
Loading...
