HikRobot ID5000 Series - Page 58

ID5000 Series Smart Code Reader User Manual
49
the specified string text, the trigger signal will be outputted.
Steps
1. Click I/O Control Settings → Input → Trigger Mode.
2. Select On as Trigger Mode.
3. Select UDP Start as Trigger Source.
4. Set Trigger Delay, UDP Trigger Port, and UDP Start Trigger Text according to actual demands.
Figure 8-28 Set and Execute UDP Trigger Mode
Set and Execute Serial Port Trigger Mode
Serial start specifies the serial port as the source for the trigger signal. When the serial port
receives the specified string text, the trigger signal will be outputted.
Steps
1. Click I/O Control Settings → Input → Trigger Mode.
2. Select On as Trigger Mode.
3. Select Serial Start as Trigger Source.
4. Set Trigger Delay, Serial Baud Rate, Serial Data Bits, Serial Parity, Serial Stop Bits, and Serial
Start Trigger Text according to actual demands.