HikRobot ID5000 Series - Page 59

ID5000 Series Smart Code Reader User Manual
50
Figure 8-29 Set and Execute Serial Port Trigger Mode
Set and Execute Self Trigger Mode
Self trigger mode allows you to trigger the device according to the trigger period you configured.
Steps
1. Click I/O Control Settings → Input → Trigger Mode.
2. Select On as Trigger Mode.
3. Select Self Trigger as Trigger Source, and set Self Trigger Period and Self Trigger Count.
4. Click Execute in Self Trigger Start to start, and click Execute in Self Trigger Stop to stop.
Figure 8-30 Set and Execute Self Trigger Mode