Video Access Control Terminal User Manual
58
3. Click OK button to finish adding.
4. You can check the checkbox of the added card and click Delete to delete the card.
Issuing Card
After adding the card to the client, you can issue it to the corresponding added person. You can also issuing the
cards to persons in batch. For details, refer to 4.1.2 Person Management.
Steps:
1. Click an added empty card in the list and click Issue Card button to issue the card with a person.
You can also double click the empty card in the card list to enter the Issue Card interface as follows.
2. Input the password of the card itself. The card password should contain 4 to 8 digits.
Note: The password will be required when the card holder swiping the card to get enter to or exit from the
door if you enable the card reader authentication mode as Card and Password, Password and Fingerprint,
and Card, Password, and Fingerprint. For details, refer to 4.7.2 Card Reader Authentication.
3. Click to set the effective time and expiry time of the card. Click OK to save the time settings.
4. Click to select a person and select a fingerprint for the card.
Note: To select the person’s fingerprint, you are required to import the fingerprint first. For details, refer to
4.1.2 Person Management.
To Next Page
Loading...
