Video Access Control Terminal User Manual
57
There are three card types: Empty Card, Normal Card, and Lost Card.
Empty Card: A card has not been issued with a person.
Normal Card: A card is issued with a person and is under normal using.
Lost Card: A card is issued with a person and is reported as lost.
Empty Card
Click Empty Card tab to manage the empty card first.
Adding Card
Before you start:
When inputting the card No. when adding the card, you can get the card No. via the following two ways:
You can get the card No. by the connected card reader. Make sure a card reader is connected to the PC and
is configured already. Refer to 8.4.2 Card Reader Configuration for details.
You can also get the card No. by scanning the card on the card reader of the access control device. For this
situation, please set the mode as Card Reader Mode in Editing Access Controller. For details, refer to 3.1.4
Editing Access Control Device.
The detected card No. will be inputted in the Card No. field automatically.
Perform the following steps to add empty card.
Steps:
1. Click Add Card button to pop up the Add Card dialog box.
2. Two adding methods are supported.
Adding Single Card
Select Single Adding as the adding mode and input the card No..
Note: Up to 20 characters are allowed in the card No., including digits or letters.
Batch Adding Cards
Select Batch Adding as the adding mode. Input the start card No. and the end card No..
Notes:
The start card No. and the last card No. should be the with same length. E.g., the last card No. is 234,
then the start card No. should be like 028.
For batch adding, the card No. should contain 1 to 10 digits and letters are not allowed.
To Next Page
Loading...
