Video Access Control Terminal User Manual
26
2. Input the device name.
3. Select the connection type in the dropdown list: TCP/IP, COM port (1 to 5), or EHome protocol.
TCP/IP: Connect the device via the network.
COM1 to COM5: Connect the device via the COM port.
EHome: Connect the device via EHome Protocol.
Note: For connection type of EHome protocol, please set the network center parameter first. For details,
refer to 3.2.2 Network Center Settings.
4. Set the parameters of connecting the device.
If you select the connection type as TCP/IP, you should input the device IP Address, Port No., User Name,
and Password.
If you select the connection type as COM port, you should input the Baud Rate and Dial-up value.
If you select the connection type as EHome, you should input the Account.
5. Click Add button to finish adding.
Editing Access Control Device
Purpose:
After adding the device, you can configure the added access control device’s parameters, its access control point
(door)’s parameters, and its card readers’ parameters.
Click to select the added access control device from the list, and then click Modify button to enter the Edit
Access Controller interface.
Notes:
After editing the device, you can click Apply Parameters to apply the configured parameters to the device to
take effect.
You can also click Read Parameters to get the device parameters from the device itself.
Editing Basic Information
You can configure the device basic information including IP address, port No., etc.
Steps:
1. In the device list on the left, select the access control device and you can edit its basic parameters on your
demand, which are the same as the ones when adding the device.
To Next Page
Loading...
