Video Access Control Terminal User Manual
68
Click icon on the control panel to enter the Status Monitor interface.
Anti-control the Access Control Point (Door)
Purpose:
You can control the status for a single access control point (a door).
Steps:
1. Select an access control group on the left. For managing the access control group, refer to 3.6.1 Access
Control Group Management.
2. The access control points of the selected access control group will be displayed on the right.
Click icon on the Status Information panel to select a door.
3. Click the following button listed on the Status Information panel to control the door.
: Click to open the door once.
: Click to close the door once.
: Click to keep the door open.
: Click to keep the door closed.
: Click to capture the picture manually.
4. You can view the anti-control operation result in the Operation Log panel.
Notes:
If you select the status as Remain Open/Remain Closed, the door will keep open/closed until a new
anti-control command being made.
The Capture button is available when the device supports capture function. And it cannot be realized until
the storage server is configured. Refer to 8.4.4 Storage Server Configuration.
To Next Page
Loading...
