Video Access Control Terminal User Manual
74
Click button to add a new client linkage. You can select the event source as Event Linkage or Card
Linkage.
Event Linkage
For the event linkage, the alarm event can be divided into four types: device event, alarm input, door event, and
card reader event.
Steps:
1. Click to select the linkage type as Event Linkage, select the access control device as event source, and select
the event type from the dropdown list.
For Device Event, select the detailed event type from the dropdown list.
For Alarm Input, select the type as alarm or alarm recovery and select the alarm input name from the
table.
For Door Event, select the detailed event type and select the door from the table.
For Card Reader Event, select the detailed event type and select the card reader from the table.
2. Set the linkage target, select the access control device from the dropdown list as the linkage target, and
switch the property from to to enable this function.
Alarm Output: The alarm output will be triggered for notification.
Door: The door status of open, close, remain open, and remain close will be triggered. Note: The door
status of open, close, remain open, and remain close cannot be triggered at the same time.
3. Click Save button to save parameters.
Card Linkage
Steps:
1. Click to select the linkage type as Card Linkage.
2. Select the card from the dropdown list and select the access control device as event source.
3. Select the card reader from the table for triggering.
4. Set the linkage target, select the access control device from the dropdown list as the linkage target, and
switch the property from to to enable this function.
Alarm Output: The alarm output will be triggered for notification.
5. Click Save button to save parameters.
To Next Page
Loading...
