Video Access Control Terminal User Manual
73
Capture: The real-time capture will be triggered.
Reader Buzzer: The audible warning of card reader will be triggered.
Alarm Output: The alarm output will be triggered for notification.
5. Click Save button to save parameters.
6. Click Apply Settings to apply the updated parameters to the local memory of the device to take effect.
MAC Linkage
You can link the device by setting the MAC address.
1. Select a device in the event card linkage list.
2. Click Add in the Linkage Details page.
3. Select MAC Linkage in the Event Source part. And input the MAC address in the text box.
4. Set the linkage target parameters, including the host buzzer the capture, the record, the card reader buzzing,
the alarm out, and the door.
5. Click Save to save the settings.
6. Click Apply Settings to apply the updated parameters to the local memory of the device to take effect.
Client Linkage
Purpose:
You can assign other access control device linkage actions to the trigger by setting up a rule in client linkage.
In the Linkage Configuration interface, click Client Linkage tab to enter the following interface.
To Next Page
Loading...
