Video Access Control Terminal User Manual
88
Example: If you select Reader In_01 as the beginning, and select Reader In_02, Reader Out_04 as the linked
card readers. Then you can only get through the access control point by swiping the card in the order as
Reader In_01, Reader In_02 and Reader Out_04.
Note: Up to four afterward card readers can be added for one card reader.
4. Check the Enable Anti-Passing Back checkbox to enable the anti-passing back function of the card reader.
5. (Optional) You can enter the Select Card Reader dialog box again to edit its afterward card readers.
6. Click Save and then click Apply Settings button to take effect of the new settings.
Multi-door Interlocking
You can set the multi-door interlocking between multiple doors of the same access control device. To open one
of the doors, other doors must keep closed. That means in the interlocking combined door group, up to one door
can be opened at the same time.
Notes:
The Multi-door Interlocking function is only supported by the access control device which has more than
one access control points (doors).
Either the anti-passing back or multi-door interlocking function can be configured for an access control
device at the same time.
Steps:
6. Click Multi-door Interlocking tab and select an access control point from the list.
7. Click Add to pop up the Add Access Control Point to Interlock interface.
To Next Page
Loading...
