HIKVISION DS-K1TA70 Series

If enable the funcon, the device can recognize the EM card. You can present EM card on the
device.
Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM card funcon.
4.
Click OK.
5.
Oponal: Click Copy to, and then select the access control device(s) to copy the parameters in
the page to the selected device(s).
Congure Parameters for Door
Aer adding the access control device, you can congure its access point door parameters.
Steps
1.
Click Access Control → Advanced
Funcon → Device Parameter .
2.
Select an access control device on the le panel, and then click to show the doors of the
selected device.
3.
Select a door to show its parameters on the right page.
4.
Edit the door parameters.
Note
The displayed parameters may vary for dierent access control devices.
●
●
Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Name
Edit the card reader name as desired.
Door Contact
You can set the door sensor as remaining closed or remaining open. Usually, it is remaining
closed.
Exit
Buon Type
You can set the exit buon as remaining closed or remaining open. Usually, it is remaining
open.
Open Duraon
Aer swiping the normal card and relay acon, the mer for locking the door starts working.
Super Password
The specic person can open the door by inpung the super password.
Door Le Open Timeout Alarm
DS-K1TA70 Series Face Recognion Terminal User Manual
137