HIKVISION DS-K1TA70 Series User Manual

The alarm can be triggered if the door has not been closed in a congured me period. If it is
set as 0, no alarm will be triggered.
Click Advanced to congure more parameters.
Extended Open Duraon
The door contact can be enabled with appropriate delay aer person with extended accesss
needs swipes her/his card.
Duress Code
The door can open by
inpung the duress code when there is duress. At the same me, the
client can report the duress event.
Note
●
The duress code and the super code should be dierent.
●
The duress code and super password should be dierent from the authencaon password.
●
The length of duress code and the super password is according to the device, usually it should
contains 4 to 8 digits.
5.
Click OK.
6.
Oponal: Click Copy to , and then select the door/oor(s) to copy the parameters in the page to
the selected
doors/oor(s).
Note
The door's status duraon sengs will be copied to the selected doors as well.
Congure Parameters for Card Reader
Aer adding the access control device, you can congure its card reader parameters.
Steps
1.
Click Access Control → Advanced Funcon → Device Parameter .
2.
In the device list on the
le, click to expand the door, select a card reader and you can edit the
card reader's parameters on the right.
3.
Edit the card reader basic parameters in the Basic
Informaon page.
Note
●
The displayed parameters may vary for dierent access control devices. There are part of
parameters listed as follows. Refer to the user manual of the device for more details.
●
Some of the following parameters are not listed in the Basic Informaon page, click Advanced
to edit the parameters.
Basic Informaon
Name
Edit the card reader name as desired.
DS-K1TA70 Series Face Recognion Terminal User Manual
138

HIKVISION DS-K1TA70 Series Specifications

General

Brand	HIKVISION
Model	DS-K1TA70 Series
Category	Touch terminals
Language	English