To Next Page

To Previous Page

Minimum Card Swiping Interval

If the interval between card swiping of the same card is less than the set value, the card

swiping is invalid. You can set it as 0 to 255.

Alarm of Max. Failed Aempts

Enable to report alarm when the card reading aempts reach the set value.

Card Reader Type/Card Reader Descripon

Get card reader type and descripon. They are read-only.

Advanced

Enable Card Reader

Enable the

funcon and e device can be used as an card reader.

OK LED Polarity/Error LED Polarity/Buzzer Polarity

Set OK LED Polarity/Error LED Polarity/Buzzer LED Polarity of main board according to the

card reader parameters. Generally, adopts the default sengs.

Max. Interval When Entering PWD

When you inpung the password on the card reader, if the interval between pressing two

digits is larger than the set value, the digits you pressed before will be cleared

automacally.

Tampering Detecon

Enable the an-tamper detecon for the card reader.

Communicate with Controller Every

When the access control device cannot connect with the card reader for longer than the

set me, the card reader will turn oine automacally.

Face 1:N Matching Threshold

Set the matching threshold when authencang via 1:N matching mode. The larger the

value, the smaller the false accept rate and the larger the false rejecon rate when

authencaon.

Face Recognion Interval

The me interval between two connuous face recognions when authencang.

Face An-Spoong

Enable or disable the live face detecon funcon. If enabling the funcon, the device can

recognize whether the person is a live one or not.

Face 1:1 Matching Threshold

Set the matching threshold when authencang via 1:1 matching mode. The larger the

value, the smaller the false accept rate and the larger the false

rejecon rate when

authencaon.

Applicaon Mode

DS-K1TA70 Series Face Recognion Terminal User Manual

139

HIKVISION DS-K1TA70 Series User Manual

Questions and Answers: