HIKVISION DS-TCG406-E - Page 20

Figure 3-4 Set Applicaon Mode
2.
Select Trigger Type.
Video Detecon
Select it to trigger capture by video stream detecon.
I/O Coil
Select it to trigger capture by external device such as the vehicle detector and radar.
Radar Mixed Trac
Select it to detect the driving direcon in mixed trac scene with two radars.
Note
If you select this type, one Forward Radar and one Backward Radar should be set.
3.
Select Picture Type.
Scene Picture
One scene picture and one license plate picture will be captured.
Scene Picture + Close-up Picture
One scene picture, one license plate picture, and one close-up picture will be captured.
4.
Set the following parameters as required.
Scene Mode
Select a scene mode as required. Select Toll Gate when there are many large-sized vehicles
and vehicle heads are not captured completely. Select Underground Parking Entrance & Exit
in low light environment. Select Entrance & Exit in other scenes.
Enable Non-motorised Vehicle Capture
Check to
idenfy and capture non-motor vehicles in the scene.
I/O Trigger Defaults Status
Intelligent Entrance ANPR Camera User Manual
12