Hillrom Affinity 4 - Pendant Control Kit with Holder-P5362, P3618 (no Longer Available); Permanent IV Pole-P222101; Procedural Light-P7925 D120; Rail and Hanger-P53120120 and P17073001

Accessories
34 Affinity® 4 Birthing Bed Instructions for Use (USR025 REV 13)
PENDANT CONTROL KIT WITH HOLDER—P5362, P3618 (NO LONGER AVAILABLE)
This kit contains a pendant control and holder to control the bed high/low,
head up/down and foot up/down functions. The holder clamps to the bed
side rail.
Make sure you stow the pendant and pendant cable when it is not in use or
when you transport the bed.
To activate—push the appropriate control(s).
PERMANENT IV POLE—P222101
The Permanent IV Pole mounts to the head section frame. The pole slides to
either side of the bed and enables additional IV bags and pumps to be
mounted. The P222101 can not be used on D model beds.
The maximum safe working load is 25 lb (11 kg).
To Deploy
1. Lift the IV pole from its stored position behind the headboard, and
position it straight up.
2. Make sure that the pole drops and locks into position.
3. Raise the upper section of the pole to the desired height. The IV pole is ready for use.
To Store
1. Grasp and hold the upper section of the IV pole. Push the upper collar down, and lower the upper
pole section into the lower pole section.
2. Lift the lower section of the IV pole up, and lower the pole down to the stored position behind the
headboard. The poles should rest in the storage slots provided on the bed frame.
CAUTION:
Caution—Make sure any IV pole mounted infusion pumps are not in the direct path of the moving head
section. Interference with head section articulation could result.
PROCEDURAL LIGHT—P7925D120
This light is mounted on a four leg base with two locking casters for stability. It is designed to provide
no-drift, shadow free, color correct light.
RAIL AND HANGER—P53120120 AND P17073001
The equipment rail (P53120120) and hanger with bracket (P17073001) are for the Affinity® 4 Birthing
Bed, Stow and Go® foot section.
SHEETS—SA1528, SA4585, SA1529, AND SA4586
A sheet set includes pillow case, top, and custom-fitted, bottom sheets. Additionally, the two-piece
bottom set is available separately.
Before the Affinity® Bed is used by a patient, sheets must be placed over the mattress.
SLIPCOVERS (HEAD AND FOOT)—P3628, P3627, P3630 AND P3631
Head Section Slipcover