Hillrom Affinity 4 - Line Manager-P3733

Accessories
36 Affinity® 4 Birthing Bed Instructions for Use (USR025 REV 13)
LINE MANAGER—P3733
WARNING:
Warning—To help prevent injury and/or
equipment damage, obey these warnings:
• Warning—Do not use the Line Manager
for ventilator circuits.
• Warning—Failure to keep aseptic lines
separate from non-aseptic lines may
cause cross contamination.
• Warning—Do not hang cords on the
Line Manager.
• Warning—When you use the Line Manager, monitor the lines to make sure they
are not pinched or kinked and there is sufficient slack for bed articulations and
patient movement.
• Warning—Failure to remove lines from the Line Manager before you transfer the patient could
cause patient injury or equipment damage.
• Warning—Do not use the line manager to move the bed.
• Warning—Do not use tape to hold lines inside the line manager.
A Line Manager is on each side of the head end of the bed. The Line Manager helps to keep lines (such
as IV infusion lines, suction lines, oxygen lines, etc.) together and away from the articulating frame. The
flexibility of the Line Manager lets you bend it in any direction.
The line manager can hold one set of the following:
• 4 monitor lines of 1/8” diameter
• 2 suction lines of 1/2” diameter
• 2 oxygen lines of 3/8” diameter
• 8 IV infusion lines of 1/4” diameter
• 1 feeding tube of 3/8” diameter