Hillrom Affinity 4 - Slipcover Upgrade Kits-P3730 and P3731; Push Handles-P1983 A01

Accessories
Affinity® 4 Birthing Bed Instructions for Use (USR025 REV 13) 35
The head section slipcover is simply placed over the head section mattress
for protection from normal wear and tear and from fluids.
Foot Section Slipcover
The foot section slipcover is simply placed over the foot section mattress for
protection from normal wear and tear and from fluids.
SLIPCOVER UPGRADE KITS—P3730 AND P3731
These upgrade kits enables upgrade from Affinity® 4 Birthing Bed lift off to “Stow and Go®” foot section.
The P3730 is for the U-cut slipcover and the P3731 is for the V-cut slipcover.
PUSH HANDLES—P1983A01
The push handles are located on the head end of
the bed and are used to move the bed.
Remove from the Stowed Position
Pull the push handles upward until they lock in
position.
To Stow
WARNING:
Warning—Make sure the patient or caregiver
hands are not in the path of travel while you lower
the transport handles. Injury could occur.
1. Lift up on the push handles to unlock
them.
2. Move the push handles in toward the
center of bed to the stowed position.
Number Description
P3627 Slipcover, head section, straight edge
P3628 Slipcover, head section, V-cut
P3630 Slipcover, foot section, straight edge
P3631 Slipcover, foot section, V-cut