System Manual Compact Systems 7 Start-Up
HI 800 141 E Rev. 2.02 Page 77 of 110
[BYTE]
0x00
0x01
0x02
0x04
0x08
0x10
Normal
Undervoltage 24 V [not safe]
Battery undervoltage [not safe]
Undervoltage 5 V [safe]
Undervoltage at 3.3 V [safe]
Overvoltage 3.3 V [safe]
64-bit ring counter
Each UDINT includes 32 bits.
[safe]
[BYTE]
0x00
0x01
0x02
0x03
Normal
High
Defective
Very high
[not safe]
Duration of the last cycle
[safe]
Emergency
stop 1, 2, 3, 4
TRUE: Emergency stop of the system
[safe]
1)
System signals with the [not safe] characteristic may only be combined with signals defined
as [safe] to trigger a safety shut-down.
2)
Currently available with the F20 controller only,
with all other systems: 0xFF = status not available
Table 47: General System Signals and Parameters - CPU OS up to V7
The following table specifies the parameters for configuring the user program:
For future applications in which a resource is able
to process multiple program instances
simultaneously.
It determines the maximum cycle time portion that
must not be exceeded by the program instance. If
this time portion is exceeded, the program enters
the STOP state.
Note: Maintain the default setting 0 (no special
cycle time monitoring).
Off, Cold Start,
Warm Start
The user program starts automatically after
powering on
Structure of the resource memory required and
expected for performing a code generation.
Compatibility with previous controller
versions is ensured.
Compatibility with future controller
versions.
Table 48: User program Parameters - up to CPU OS V7
The parameters specified above can be accessed via the ELOP II Factory Hardware
Management.
To Next Page
Loading...
Need help?
General
