Hioki DM7275 Series - Page 107

105
Preparing to Use an Interface (Connection and Settings)
(1) Set the communications conditions.
Checkthesettingsbeforeconguringthem.
The settings for both the instrument and external devices differ depending on whether you are
connecting the instrument to an existing network or creating a new network consisting of the
instrument and a single computer.
Connectingtheinstrumenttoanexistingnetwork
The following settings must be assigned in advance by the network system administrator
(department). Be sure not to use settings that are already in use by another device.
• Instrument’s address setting
IP address: ................................ ___.___.___.___
Subnet mask: ............................ ___.___.___.___
• Gateway
Whether to use a gateway: ....... Use / Do not use
IP address (if using): ................. ___.___.___.___ (If not using, set to 0.0.0.0.)
• Port number used by communications commands: ____ (Default: 23)
Creatinganewnetworkconsistingoftheinstrumentandasinglecomputer
(Using the instrument on a local network without any outside connection)
It is recommended to use the following addresses if there is no administrator, or if the settings are
left to your discretion:
(Example settings)
IP addresses
Addresses should be assigned in order, for example:
Computer: 192.168.0.1
First instrument: 192.168.0.2
Second instrument: 192.168.0.3
Third instrument: 192.168.0.4
Subnet mask: ................ 255.255.255.0
Gateway: ....................... OFF
Port number: ................. 23
8
Preparing to Use USB, RS-232C, GP-IB, and LAN Control
w ww . . co m
information@itm.com1.800.561.8187